Step | | Procedure & Parts & Tools |
1 |
|
Turn the machine off and disconnect the batteries.
|
2 |
|
Using a 5mm Allen wrench, remove the 3 screws from the power electronics.
Wrench-Allen metric 5.0mm |
|
|
3 |
|
Pull to remove the power electronics.
|
4 |
|
Squeeze and pull to disconnect the plug labeled stepboard.
|
5 |
|
Locate the limit switch under the stepboard.
|
6 |
|
Using a 6mm Allen wrench, remove the 4 screws holding the stepboard.
Wrench-Allen metric 6.0mm |
|
|
7 |
|
Slide the stepboard out.
|
8 |
|
Using a small Phillips screwdriver, remove the screw holding the limit switch.
Screwdriver-phillips |
|
|
9 |
|
Using a small flat head screwdriver, gently pry the limit switch loose.
Screwdriver-flat tip |
|
|
10 |
|
Pry the limit switch loose until it comes out of the hole shown here.
|
11 |
|
Pull the limit switch under the stepboard support weldment. Note: Stop here and make sure the machine is off and the batteries are disconnected.
|
12 |
|
Locate the wires for the limit switch and squeeze and pull to unplug them from the power electronics.
|
13 |
|
Pull the limit switch forward and cut the wires.
Wire cutters |
|
|
14 |
|
From the power electronics, pull the plug and wires to remove them from the machine. Reverse steps to install a new limit switch.
|